
Heating and Cooling in Edgewood, NM
Heat comes first at 6,700 feet. We plan the 45-minute drive around that and tell you the real timing.
- NM CID License #413436
- 24 Google reviews
- Led by Dominic Montoya, over 20 years in the trade
- Free written estimates
Red Wrench serves Edgewood, about 45 minutes from our Paradise Blvd base along I-40. Heating and cooling Edgewood homes is mostly a heating job at 6,700 feet, and the common assumption that everyone here burns propane does not match the numbers. Most homes are on utility gas, with a real minority on tank propane, wood or electric heat.
Santa Fe County Town Limits and the State Road 344 Permit Order
Check the local step first. Edgewood is an incorporated town in southern Santa Fe County, and annexations have carried its limits past the county line. Town zoning rules send development permit applications to the Planning and Zoning administrator for review and signature before a State permit application goes to the Construction Industries Division. Town offices are at 171 State Road 344.
Equipment swaps may not need that zoning step, so ask the town what applies to your job. For the mechanical side, the state says a licensed contractor pulls the furnace replacement permit before the work. Any bid you take should state who pulls it, and ours does.
The town is also larger than it looks. Census records show about 57 square miles of land for roughly 6,200 residents. A call on the far side of the limits can add real minutes beyond the drive quoted above.
Which Fuel Runs an Edgewood Furnace?
Census estimates for 2020-2024 break down occupied homes like this:
| Heating fuel | Share of homes |
|---|---|
| Utility gas | 58% |
| Tank propane | 16% |
| Wood | 13% |
| Electricity | 10% |
Margins are wide on these estimates, so treat them as a shape and not a count. They still change how we prepare. Ask what you have before pricing a heat pump, because the savings case differs for each fuel.
Housing tells the rest. The median home dates to 1997, about 35% of homes went up in the 1990s, and roughly 24% are manufactured. A 1990s furnace can be 30 years old by now, and a manufactured home needs a furnace built for that use.

Wind, Spring Snow and What to Book Ahead
Plan for weather that can arrive late. An observer near Edgewood logged 13 inches on April 5, 2025, among the largest one-day snow totals in the National Weather Service's Albuquerque summary for that year. Wind matters too. In April 2011, Santa Fe County reported gusts knocking down transmission poles and cutting power around Edgewood and Stanley.
The electric provider here is Central New Mexico Electric Co-op, so check with them during an outage before you assume the furnace failed. A gas furnace still needs power for its blower and controls.
Book these before the season turns:
- Furnace maintenance in early fall, ahead of the first long cold stretch
- Swamp cooler repair and startup in late spring
- Mobile home furnace service if the unit is original to the home
- Heat pump installation quotes during mild weather, when no one is rushed

Heating and Cooling Edgewood on a 45-Minute Drive
We answer the phone 24 hours a day at (209) 563-1270, but we will not promise a quick arrival over this distance. We tell you what the schedule and the road allow, and you decide. Planned visits are where this drive works best, and the free written estimate comes before work starts either way.

Services most needed in Edgewood

Furnace Repair
Edgewood sits near 6,700 feet with 58% of homes on utility gas and 16% on tank propane, so the technician confirms the fuel, then checks burners and venting against the high-altitude instructions.

Furnace Maintenance
An observer near Edgewood logged 13 inches of snow on April 5, 2025, so heat can still be needed deep into spring, and a fall tune-up has to carry the system that far.

Heat Pump Installation
About 10% of Edgewood homes heat with electricity and 13% burn wood, so those owners have the most to compare. Any quote should address cold at 6,700 feet and co-op power outages.

Mobile Home Furnace Service
Roughly 24% of Edgewood homes are manufactured, about 570 by Census estimate, and a 1990s original can be 30 years old. Its replacement must be built for that housing, not a standard household furnace.

Swamp Cooler Repair
Edgewood sits about 500 feet above the Moriarty station, where NOAA normals show just 414 cooling degree days, so a cooler has a short season and spring startup fits a planned trip along I-40.

Furnace Replacement
About 35% of Edgewood homes date to the 1990s, so surviving original furnaces are near 30 years old. Ask the town at 171 State Road 344 whether zoning review applies before the state permit.

Air Purifiers and Filtration
Wood heats about 295 Edgewood homes, roughly 13%, and stove smoke can reach the return air on a closed-up winter day, so a better filter sized for the existing furnace is worth pricing.
Nearby areas we serve
What customers say about Red Wrench
From our Google reviews. Neither reviewer names Edgewood.
“Had a entirely new unit installed new furnace new tubing all the works . Excellent job great communication even loaned me 3 window units to use while my ac was down. And installed a new thermostat for me . Highly recommend . A+++”
“Responded quickly and professionally to a furnace failure in a high demand time period. Job completed the same day and was reasonably priced. Definitely recommend. Judith”
Edgewood heating and cooling questions
Does everyone in Edgewood heat with propane?
No. Census estimates show about 58% of occupied homes on utility gas and about 16% on tank propane, with wood and electricity making up much of the rest. Your own lot may differ from your neighbor's. Check the gas meter or tank before you call, and we will prepare for that fuel.
How quickly can you get to Edgewood on a no-heat call?
We cannot promise a fast arrival. The drive alone runs about 45 minutes from Paradise Blvd in normal conditions, and storms on I-40 can stretch it. Call anyway, because the phone is answered around the clock. We will give you honest timing and safe steps to take while you wait.
Do I need a permit to replace a furnace in Edgewood?
Yes, a permit is required. The state Construction Industries Division says a licensed contractor must pull it before the work is done and inspected. Town zoning review applies to development, so ask Edgewood's Planning and Zoning office whether your project needs that step too. Your quote should name who handles each piece.
Our Albuquerque base
Red Wrench Company
5635 Paradise Blvd NWAlbuquerque, NM 87114
Open 24 hours, 7 days a week
Need heating or cooling help in Edgewood?
Call any hour. You get a straight answer, a free written estimate and the price before the work starts.
- NM CID License #413436
- 24 Google reviews
- Led by Dominic Montoya, over 20 years in the trade
- Free written estimates
Red Wrench Company, 5635 Paradise Blvd NW, Albuquerque, NM 87114, (209) 563-1270


